Jump to content

Need kexts for


  • Please log in to reply
3 replies to this topic

#1
bmttinman

bmttinman

    InsanelyMac Protégé

  • Members
  • Pip
  • 44 posts
  • Gender:Male
I have almost got Snow Leopard install on EP45T-UD3P with ATI 4850 on separate hard drive using the video “Retail Snow Leopard install to gigabyte ep45-ds3r” on http://osx86install.com/ except I can’t get it to boot. Have reinstalled three times but I can’t get the Extra file kext right. I have used ever kext I can find on line but to no avail. It goes threw boot but goes into panic at the last. As it boots it shows that JMicon has not booted. Has anyone got the kext that I should have for this board? Please!!!

Update Oct 3 2009

Still can't get running. Have tried every web site and post. Have tried ever kext pack that I can find. Have tried several times to get thumb-drive to make startup disk as to Lifehacker site and varies postings on this site. I can get boot loader to work on standard drives but when I try to install Snow leopard disk it goes so far locks up then have to reboot. When reboot starts it reset bois to default and have to redo bois.  

#2
dparada78

dparada78

    InsanelyMac Geek

  • Members
  • PipPipPip
  • 110 posts
did you try to boot with -v -x32....or -x perhaps....and post as pic of your kernel panic...you might need legacyjmicronata.kext...

#3
machinist

machinist

    InsanelyMac Protégé

  • Members
  • PipPip
  • 86 posts

I have almost got Snow Leopard install on EP45T-UD3P with ATI 4850 on separate hard drive using the video “Retail Snow Leopard install to gigabyte ep45-ds3r” on http://osx86install.com/ except I can’t get it to boot. Have reinstalled three times but I can’t get the Extra file kext right. I have used ever kext I can find on line but to no avail. It goes threw boot but goes into panic at the last. As it boots it shows that JMicon has not booted. Has anyone got the kext that I should have for this board? Please!!!


Try disabling the jMicron ports in your bios and set all to AHCI.

Try the ProjectSnow guide as it is explicitly for the EP45T-UD3P.

#4
bmttinman

bmttinman

    InsanelyMac Protégé

  • Members
  • Pip
  • 44 posts
  • Gender:Male
Here is snip shot of the last screen and resent try on my sysem

Try disabling the jMicron ports in your bios and set all to AHCI.

Try the ProjectSnow guide as it is explicitly for the EP45T-UD3P.


Have try this and everything in between Check this screen shoot

Attached Files







0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

© 2017 InsanelyMac  |   News  |   Forum  |   Downloads  |   OSx86 Wiki  |   Designed by Ed Gain  |   Logo by irfan  |   Privacy Policy