alkex Posted February 10, 2009 Share Posted February 10, 2009 Hi I purchased an X1900 XTX When I read It works out of the box with 10.5.2 but I can't get it working. I was hoping someone out there has this card working and could point me to the light! Thanks in advance Alex Link to comment Share on other sites More sharing options...
lebidou Posted February 10, 2009 Share Posted February 10, 2009 Hello, have looked at it http://www.insanelymac.com/forum/index.php?showtopic=58988 ? have you set correct EDID value in your injector's Info.plist ? what is the device id for that card ? Link to comment Share on other sites More sharing options...
Bettarg Posted February 13, 2009 Share Posted February 13, 2009 Hello, have looked at it http://www.insanelymac.com/forum/index.php?showtopic=58988 ? have you set correct EDID value in your injector's Info.plist ? what is the device id for that card ? Hello, the ID is 7240. I have the same Card and a LOT of problems to bring to work. In the End , it is nearly Perfect , all but the ability to change the Gamma / Brightness and so on work for me. But honestly i dont know what i have done that i works. i tryed so many different NATI´s and Kext.... Good luck guy! Link to comment Share on other sites More sharing options...
lebidou Posted February 13, 2009 Share Posted February 13, 2009 Theorically, it would work with the kext from the link I posted above, but I just can't help if alkex doesn't say if it did work or not. Link to comment Share on other sites More sharing options...
gengstapo Posted February 14, 2009 Share Posted February 14, 2009 shouldnt be a problem. IIRC, there is MacPro batch with X1900XT, try used the official driver. XT & XTX almost similar gud luck Link to comment Share on other sites More sharing options...
Recommended Posts