Adrianr Posted April 15, 2008 Share Posted April 15, 2008 Hey all, Did a quick search and found how to make the Leapord parition active if returning a b0 error, but i need to get back into Windows and it's just returning a b0 error everytime. Partitioned using Acronis, and activated OS Selector. On previous attempted the Disk Utility couldn't properly see the partitions on my hardrive, so i was amazed upon downloading the latest Kalyway 10.5.1 that everything was seen and erased acordingly. Installed Leapord on the OSX partition i had made, restarted, and it came up with the dreaded "Please restart your computer" message over and over. Not to worry i thought, i can deal with that in a minute, i'l just pop back to Windows. Which it seems i cant do. Previously i would have put my install disc in (windows install) ran command prompt and done the whole "list disk list partition set partition active" trick, but as i seem to have misplaced that it puts it off the cards. Anyway to do this VIA the osx disk? Or maybe via a DOS usb bootable flash drive? I tried the activate partition using Terminal fdisk but it brings up a load of stuff i don't quite understand! If this is the only way, could someone run me through that in detail assuming my windows partition is first, OSX second and a FAT32 shared partition third? Thanks!! Link to comment https://www.insanelymac.com/forum/topic/99420-help/ Share on other sites More sharing options...
Recommended Posts