Athlium Posted April 8, 2008 Share Posted April 8, 2008 First I want to give thanks to all that helped with their other posts to make this possible after month of searching. This is a single boot system My Hardware Specs: Intel D945Psn Board Intel Pentium D 820 Proc (2.8GHz) Stock Heatsink EVGA Nvidia 6600GT 128MB PCI-E 2GB DDR2 667 Ram from OCZ Maxtor 6V300F0 300GB SATA Drive Samsung SH-S202G IDE DVD Burner Antec Sonata 1 Case w/ upgraged 480W PSU I had windows XP installed on this PC for about a year had all the updated kept System Setup information <Main> Bios Version: SN94510J.86A.0103.2007.0903.0338 Processor Type: Intel Pentium D CPU 2.80GHz SW Single Processor Mode <Disable> rest is default <Advanced> Disabled Floppy Controller Disabled Serial Port rest is default <Security> all is default (not sure if this is default but XD Technology is Enabled) <Power> all is default <Boot> Boot Menu Type <Normal> Boot Device Priority <CD/DVD-Rom Drive> <Hard Disk Drive> <Floppy> rest is default On with the install Get the Kalyway DVD from you know where. Insert DVD into drive and watch it boot. (or not as this will take a few minutes) it should boot into the install menu after a few. Follow the onscreen prompt untill you get to choose the disk for install. Go to the top of the screen and choose Disk Utilities.(this will take a couple minutes to load) I selected the Disk (very top on the left side of the window) and choose partition, 1, named it Leopard. at the bottom there should be a options button. click it and choose GUID. (as this is a single boot) click ok. It should erase and partition new disk. exit Disk Utilties Choose the disk and on the next screen make sure you choose customize. in this menu, I choose GUID at very bottom options and also chose NVinject desktop as I have a Nvidia card. install Kalyway. (it will verify the DVD media first, I usually click skip as it takes a while) After install, boot back in to Install DVD as we need to activate the partition. Once you are back in to the DVD, open up Terminal diskutil list fdisk -e /dev/rdisk0 (Your's disk number) p f 2 (mbr=1, guid=2) write yes exit reboot , take dvd out. Now Your's bootdisk right second partition is activated after you have done that it should boot in to your Hackintosh now follow this post http://forum.insanelymac.com/index.php?s=&...st&p=660826 up to step 4 as I could not use step 5 after step 3 your system will hang for a while during the reboot. This is normal. take a few to apply changes. I also notice that sometime my machine will error out on reboots, just turn off machine for about 10 seconds and it should boot back in. now you should have everything working other than sound. follow this post http://forum.insanelymac.com/index.php?s=&...st&p=662234 which is what worked for me for my sound after 3 weeks of searching make sure you repair disk permissions after applying the package In terminal: diskutil repairPermissions / after applying, reboot and sound should now come out of the blue port in the back. Hope this guide helps. as it's my first guide. Mods please edit as you see fit. Link to comment https://www.insanelymac.com/forum/topic/98196-total-noob-install-guide-for-d945psn-board-with-kalyway-1051/ Share on other sites More sharing options...
Recommended Posts