Jump to content
1 post in this topic

Recommended Posts

I understand that with revision 2 that there is no need to run the darwin_boot commands during the setup process. Apparently it is automatic but I'm not sure if that means I still need to select any options under the "custom" dialogue right before the installation or just straight up install it as is.

 

I am running a Thinkpad T61p with:

T7700 Core2Duo

4gb ram

FX570m Quadro

Vista Ultimate (Fresh install, doing this as a dual boot installation)

Link to comment
https://www.insanelymac.com/forum/topic/96234-iatkos-v1-r2-custom-install/
Share on other sites

×
×
  • Create New...