philminatz Posted January 25, 2008 Share Posted January 25, 2008 Hi, I installed the Kalyway 10.5.1 sse2, sse3. The installation went very well. But when I reboot, it bings up Darwin for about a millisecond and then reboots, and then repeats over and over. If I stop it and do F8 and add -f -v -x, etc, same result. too fast to see the loading and then reboot. Is my P4 prescott supported? I saw some mention of setting the no-execute bit, but my cpu doesn't have that option. I tried all options: vanilla, no vanilla, nvinject, no nvinject, sse2, no sse2. Partition is MBR and so is the efi. Any suggestions? Thanks... Asus P4C800-E Deluxe P4 Prescott, 3.0Eghz 1gb crucial 1 160gb seagate sata geforce fx5200 Link to comment https://www.insanelymac.com/forum/topic/83476-boot-loop-after-install/ Share on other sites More sharing options...
virtualsim Posted January 25, 2008 Share Posted January 25, 2008 Make sure your Volume name (partition name) set in the Disk Utility is a single word. NO SPACE. Link to comment https://www.insanelymac.com/forum/topic/83476-boot-loop-after-install/#findComment-592932 Share on other sites More sharing options...
philminatz Posted January 25, 2008 Author Share Posted January 25, 2008 Yep, it's simply: OSX Link to comment https://www.insanelymac.com/forum/topic/83476-boot-loop-after-install/#findComment-592946 Share on other sites More sharing options...
Recommended Posts