Jump to content

nforce issues? - Can't see hard drive


1 post in this topic

Recommended Posts

So, i'm sure this has been asked many-a-times, but unfortunatly the search function of the forums is a pain do to the sheer size of the forums now.


I'm currently attempting to dual-boot my HP dv9408ca with Windows Vista.


The hardware itself breaks down as follows:


CPU: 1.70 gigahertz AMD Athlon 64 X2 Dual-Core TK-53

Board: Quanta 30B9 65.28

HDD: ST916082 1AS SCSI Disk Device (160.04 GB) -- drive 0 (belarc sees this as scsi, but the part number is listed by seagate as sata...)

RAM: 958 Megabytes Installed Memory

nvidia nforce sata controller

nvidia gforce Go6150


My issue is that I can't get the installer (or the disk utility) to see the 10GB partition that I have flagged for the install. I've attempted the install with both the JAS 10.4.8 and uphuck 10.4.9 disks... zero luck.


Any general suggestions on where i should go from here?


Link to comment
Share on other sites


  • Create New...