Jump to content

new install osx86 10.4 won't boot


1 post in this topic

Recommended Posts

ok im using a toshiba a135-s4656

Processor Type : Celeron® M merom 520 @1.60 ghzProcessor Number : 520 Bus : 533MHz

mmx sse sse2 sse3 ssse3em64t

Memory Size


Memory Speed

PC4200 DDR2 533MHz SDRAM

Graphics Engine

Intel® Graphics Media Accelerator 950

Graphics Memory

8MB-64MB dynamically allocated shared graphics memory


ok so the instalation went ok once i figure out that my hard rive were there and i just ahd to partionion them for mac

i then installed the os no problems


but when i boot from this drive i get hese messages and it just ignored the drive and boots from the second drive as windows




intel undi, pxe-2.1(build 082)

copyright© 19997-2000 intel corporation


for realtek rtl0100e/8101e fast ethernet networkadapter v1.02 (060510)

pxe-e61: media test failure, check cable

pxe-m0f: exiting pxe rom.




im using an external usb drive to boot from the disk manager in the installer seems to see my hard drive the internal drive is sata



edit : apprently this error is common on toshibas when the hard drive doesnt boot it tries to boot from the network and crashes


so im going to swap hard drives and try an install on the internal sata later tonight

Link to comment
Share on other sites


  • Create New...