bassistFA Posted August 27, 2007 Share Posted August 27, 2007 I have a working osX86 10.4.10 on my pc. I used following instructions: http://coolblog.profit42.com/2007/07/03/up...ual-boot-guide/ everything works i.e. Sound, Graphik-card (i´m able to change resolution), USB Then I installed Final cut studio 2 and tried to open final cut pro. FCP loads a lot of things seeing at the start screen, but then following messag appears. "unable to locate the following devices: PAL 720" There are two buttons: "Continue" or "Check again". If I click "Check again", the message doesn´t disappear. If I cklick continue, the message disapears but final cut pro is closed, so I´m not able to start fcp. I have tried it with final cut studio 1, final cut studio 2 and final cut pro 5... everytime the same message. I have it also tried with a new user & with fsprescue in the system profiler, when I click "firewire" there comes the message, that the max speed of my firewire is 400 MBit... this means, I have a working firewire connection, or not??? my system: Intel P4 530J Asus P5GDC deluxe Motherboard Geforce 6200, 128 MB Ram (from MSI) I installed following drivers: VGA -> nVidia -> Natit 0.1 System -> ICH8, ICH6 System -> Azilia Audio Thank you for your help!!! Link to comment https://www.insanelymac.com/forum/topic/61517-unable-to-start-fcp/ Share on other sites More sharing options...
Spitt Posted October 16, 2008 Share Posted October 16, 2008 I've got the exact same problem as you. Did you already find a solution? Link to comment https://www.insanelymac.com/forum/topic/61517-unable-to-start-fcp/#findComment-933212 Share on other sites More sharing options...
Guest cavallo Posted October 17, 2008 Share Posted October 17, 2008 i had the same when i disconnected rj45 cable from the on board lan everything went well. Link to comment https://www.insanelymac.com/forum/topic/61517-unable-to-start-fcp/#findComment-933415 Share on other sites More sharing options...
Recommended Posts