dotpage Posted December 1, 2005 Share Posted December 1, 2005 I installed on my laptop, on a clean HD, using the Tiger-X86_flat IMG, used several diferent parameters on dd for skip and bs, all them resultin in successfull install but fail to boot (b0 error) this is the hardware: -IBM Thinkpad R40 type 2681-CU1 -Pentium 4 M 1.8GHZ -1GB RAM -ATI Mobility 7000 16MB I also tried to install on my desktop (i915), from the install DVD, it runs on hte desktop, but if I bring the HD to the laptop, I get the "hardware not compatible" {censored}. Please help!! []'s Eduardo Link to comment https://www.insanelymac.com/forum/topic/5208-b0-error-after-deadmoo-install/ Share on other sites More sharing options...
ziina Posted April 21, 2006 Share Posted April 21, 2006 me too b0 error help plz Link to comment https://www.insanelymac.com/forum/topic/5208-b0-error-after-deadmoo-install/#findComment-100474 Share on other sites More sharing options...
mergedallhere Posted April 21, 2006 Share Posted April 21, 2006 i followed this guide and it works like a charm? http://wiki.osx86project.org/wiki/index.ph...le_And_Accurate Link to comment https://www.insanelymac.com/forum/topic/5208-b0-error-after-deadmoo-install/#findComment-100492 Share on other sites More sharing options...
muzzymate Posted April 21, 2006 Share Posted April 21, 2006 I had this problem initially after wiping my hard drive to put OS X on it and had to use a Windows 98 boot floppy disk and mark the OS X partition active (though obviously the Windows 98 boot disk doesn't know it's an OS X partition, just a non-DOS partition). After that, no more b0 error for me and OS X boots. I was using the myzar disc though. If it's a different issue with the Deadmoo installation that then might not help you. Link to comment https://www.insanelymac.com/forum/topic/5208-b0-error-after-deadmoo-install/#findComment-100537 Share on other sites More sharing options...
Recommended Posts