Jump to content
5 posts in this topic

Recommended Posts

Thanks for the replies, but I'm still very confused. @greg i read through the link but it wasn't clear what i need to do to make my hard drives appear during the install. I would like to install to either my 80Gb IDE or a 20Gb partition on my 250Gb SATA. Modifying kext sounds a bit over my head.

 

@rumble Thanks for the suggestion, but that didn't work. Normally I just leave the controller set to both.

 

Any other ideas?

Managed to get this installed on my empty 80Gb IDE HD. But now it won't boot at all. I didn't make a partition just installed. Do I need to make a partition? Booting from the dvd shows the OS is there. Is there anything I can try to make this boot?

×
×
  • Create New...