Working On Nforce4 (but have some questions)

[Guest Let The Metal Flow]

After a lot of work and after reading tons of guides i am almost satisfied.

 

Hardware:

 

DFI NF4 Ultra-D

Winchester 3200+

6600gt

USB Mouse and Keyboard (run perfectly)

 

How?

 

Have to use PATA HD (14.2GB ATA66), SATA don't work. To have decent speed (at the first start cpu usage was almost 100%) have to delete AppleTPMACPI.kext from Extensions folder ( http://wiki.osx86project.org/wiki/index.php/SpeedBoost ). Maxxuss SSE3to2 Patch installed and ROSETTA fully functional. To make active Audio and Dma I used Hacked kext files AppleAC97Audio.kext & IOATAFamily.kext from ( http://forum.osx86project.org/index.php?sh...3851&hl=nforce4 ) that are working perfectly. After these tricks speed is really good (i have really fast ock cpu and rams).

Besides I've Installed 10.4.1to10.4.3 Patch from this thread ( http://forum.osx86project.org/index.php?sh...=3949&hl=nvidia ), but system is still recognized how 10.4.1.

 

What's wrong:

 

Installed Macvidia Nvidia.kext and edited, 6600gt recognized but haven't noticed any changes in video acceleration. (possible solution?)

 

All Gigabit Lans aren't recognized by system. (possible solution?)

 

Don't understand how to set a fixed resolution and refresh rate without write all times in boot loader. (still running 1024x768 at 60hz. (possible solution?)

 

Anotherer question: I have full dvd 10.4.3 dmg (about 3GB) but when i try to boot from dvd burned with this image says my hardware cannot run with osx86. If I start form system says me to reboot but nothing changes. What I can do to install from dvd and have full 10.4.3 and personalized installation?