Anthon Posted February 7, 2007 Share Posted February 7, 2007 Hello to all of you! Finally I have a real Tiger at home Used JaS 10.4.8 with SSE2 & SSE3 patch. Computer Specs: Asus P4S800D P4 3000Mhz HT 1 Gb RAM Maxtor 20Gb IDE Disk (SATA controller is not recognized) Club ATi 9600 PRO AGP 256Mb Sound Blaster Live Value Samtron 76E 17" CRT I have only a few questions. Obviously I have searched the forum but not all went well 1. Change resolution + refresh rate. Installed Katana but that screwed my installation and had to do it all again... What is the best how to for my graphic card? "Type: Display Bus: PCI VRAM: 256 MB Vendor: ATI (0x1002) Device ID: 0x4150 Revision ID: 0x0000 Display: Resolution: 1024x768 Depth: 32 Core Image: Supported Main Display: Yes Mirror: Off Online: Yes Quartz Extreme: Supported" 2. Onboard SiS900 Network Card = bullsh**. Is there any hope for this network card? Thank you all for this great community Best regards, Anthon. Link to comment Share on other sites More sharing options...
Guest bikedude880 Posted February 7, 2007 Share Posted February 7, 2007 For the video, look for 9600 here: [How To] Solutions for Video Problems, A Compilation Link to comment Share on other sites More sharing options...
Anthon Posted February 7, 2007 Author Share Posted February 7, 2007 Good morning I have used a script ATiScript0.2 that was mencioned at one of the tutorials. At the first use "sudo /.doe.sh none 1152x864x32" it did nothing.... My res. was the same and the system was a lot slower... Tried another time with "sudo ./doe.sh 08 1152x864x32 1 1" and then the system hanged during start up... I'm going to install Tiger again and let the res. at 1024x768@60Hz... Better to have something than nothing Thanks anyway. Best regards, Anthon. Link to comment Share on other sites More sharing options...
Anthon Posted February 18, 2007 Author Share Posted February 18, 2007 Hey again I have managed to install CallistoFB (008) and modify the 9700 kext. Now I have resolution/refresh rate customization. But, I would like to add a new resolution to my monitor profile! I only have 1024x768 & 1280X800, when I wanted 1152x864 too. How can I do this? I have searched in "com.apple.MonitorPreferences" and some other files but with no luck... Thanks Link to comment Share on other sites More sharing options...
Recommended Posts