Jump to content
30 posts in this topic

Recommended Posts

Good evening.

After several unsuccessful attempts and a lot of research on the web. I recovered this EFI which I modified: it corresponded to my motherboard with the same processor. It seemed like a good base to me. But a graphics card declared in this EFI did not match. After deleting everything corresponding to it, I added whatergreen absent in the kext folder: I used OpenCore auxiliary tools for that.

What is missing or what have I forgotten?

P1010475.jpg

EFI.zip

Link to comment
https://www.insanelymac.com/forum/topic/352653-how-to-fix-this-boot-error/
Share on other sites

I'm very close to installing it now. I changed the boot argument (-v keepsyms=1 alcid=1) and true for RebuildAppleMemoryMap . Something surprises me. verbose mode is in a loop. several lines are repeated. I didn't think that possible. I will plug in a wired keyboard and mouse and remove the logitech (blutooth) dongle. I think this is the source of this error and change the lP1010496.thumb.jpg.d2936572713a6bada1b2d6bf855d7149.jpganguage (french)

Guest ricoc90

I don't think that Bluetooth is the source. Your picture shows me that the installer booted just fine, but for some reason doesn't load the GUI. Verbose mode always is "in a loop", it just prints out what macOSĀ  is (or its processes are) doing.
I would redownload macOS and create a new installer, just to rule out a corrupted image.

I just tried a wired apple keyboard and a wired logitech mouse. This time I go almost to the end, but I get this message: a mouse is displayed with the mouse pointer at the top of the screen on the left but the logitech does not respond? With at the bottom of the screen: support.apple.com/macsetup? I can download a version of 12.4 again (fortunately, I have fiber... with an old Imac 27')

Guest ricoc90

Make sure xhciportlimit is enabled and usbinjectall.kext is in your efi. If they already are but still not working then I wouldn’t worry about it too much as long as the ports on your motherboard are in fact working. Id focus on getting macOS installed first, because then you’re able to properly map the USB ports.

I haven't advanced an inch! However, I started from versions downloaded last night: A 12.4 and even a 12.5 I get to the same screen with this bluetoothd error. I tried to use only the USB2 ports but without success. I searched the web but did not see anything! Does anyone have a suggestion?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...