Jump to content

No DP signal after upgrading Clover to r5109

1 post in this topic

Recommended Posts

Hello all,
I had my config up and running (which has a RX 5700 XT) using WG and Lilu kexts, and agdpmod=pikera flag in config.plist with Clover r5108.
Now that I upgraded to Clover r5109 (from Clover Configurator) and rebooted, after finishing loading my screen does not receive any signal from DP. Tried also the HDMI port with no luck.
It was the same issue I had with r5108 before using the pikera flag, the problem is that now the flag is present.

How can I solve the issue?
Thanks in advance.

Edited by scleone1987
Link to comment
Share on other sites


  • Create New...