Blackscreen on Clover Boot when using RX580

[ruiloureiro]

I have installed Catalina (10.15.3) on my desktop, using this guide (made for my motherboard): https://mcdojf.wixsite.com/z68x

 

My specs are:

Motherboard: Gigabyte Z68X-UD3H-B3

CPU: Intel i5 2500k

GPU: Sapphire RX 580 Nitro 8GB

RAM: Corsair Vengeance 8gb DDR3

 

I'm unable to boot when using my dedicated gpu (sapphire RX580).

After the clover menu, the screen goes black and flashes and flickers from time to time.

 

The last log message I see is IOConsoleUsers: gIOScreenLockState 3, hs 0, bs 0, now 0, sm 0x0

 

 

Since I don't have a DP cable, I've only tried HDMI.

When I disconnect the RX580 and use my igpu, it boots normally.

 

When I try to disable CSM on the motherboard BIOS and I have the RX580 connected, the CSM goes back to enabled when I restart.

Without the RX580 (using the igpu), the CSM stays disabled and I can boot fine.

 

The RX580 was bought secondhand, but I have used it in windows without any issue for 3 months.

 

Below I have attached my clover folder.

 

Any help will be greatly appreciated.

CLOVER.zip

Edited April 1, 2020 by ruiloureiro