Baseplate1337 Posted September 27, 2019 Share Posted September 27, 2019 Hello, I have a build running on the following : -Biostar H61MLV3 -Intel Core i5 3330 -4GB DDR3 RAM -Palit Geforce GT710 I ran the installation before I got the gt710 and I had it running on my iGPU which has no hardware acceleration so I bought the gt710 as it is based on kepler and should work OOB. However when I try booting, I get a black screen with flashing messages that keep appearing and disappearing, I believe this message keeps reoccuring. IOConsoleUsers: gIOScreenLockState 3, hs 0, bs 0, now 0, sm 0x0 The os boots with nv_disable=1 flag though. Link to comment Share on other sites More sharing options...
Baseplate1337 Posted September 28, 2019 Author Share Posted September 28, 2019 (edited) I get "NVDAGK100HAL loaded and registeted" message, so it is a kepler based GPU. I ran a live linux distro and used lspci -v I have attached the result of the command. Probably a config issue? Edited September 28, 2019 by Baseplate1337 Added an attachement for the GPU architecture Link to comment Share on other sites More sharing options...
Baseplate1337 Posted September 28, 2019 Author Share Posted September 28, 2019 (edited) Thanks for the reply, I've used both a HDMI TV and a VGA monitor (used a hdmi to VGA adapter in here). I get a black screen with no output whatsoever on the HDMI TV. However on the VGA monitor (with the adapter) here is the result): Tried using your NVCAP method, no luck too. :/ This is my EFI folder. Edited September 28, 2019 by Baseplate1337 Trying NVCAP, no luck. Link to comment Share on other sites More sharing options...
Baseplate1337 Posted September 28, 2019 Author Share Posted September 28, 2019 1 minute ago, Hervé said: I think we had already understood about your black screen issue. Are you going to stop there or provide the rest? I haven't seen your edit about uploading the EFI folder until later on, I have already added it just before you added this reply. ^^ Sorry mate, EFI is added on my previous reply. Link to comment Share on other sites More sharing options...
Baseplate1337 Posted September 28, 2019 Author Share Posted September 28, 2019 I have tried to attach it but there is a size limit, fully noted though and sorry for any inconvenience. Link to comment Share on other sites More sharing options...
Baseplate1337 Posted September 28, 2019 Author Share Posted September 28, 2019 No luck, black screen and apparently signal is lost. Link to comment Share on other sites More sharing options...
Baseplate1337 Posted September 28, 2019 Author Share Posted September 28, 2019 Full vanilla. Link to comment Share on other sites More sharing options...
Recommended Posts