abxnightpilot Posted March 17, 2015 Share Posted March 17, 2015 (edited) I ran audio_realtekALC-100v1.0.4d.command and was able to get internal audio on my z87x ud5 th. HOWEVERI then went through the TonyMac Fix iMessage guide and something I did disabled my audio. I no longer have an output device to select in System Preferences> Sound. I tried to run audio_realtekALC-100v1.0.4d.command again but after entering my password it asks me to "Enter Codec" instead of "Verify Codec - y/n?"I am very new to clover and the iMessage guide took almost 15 hours to get through. That being said, PLEASE keep it simple.Thanks NEW INFO: I just came across something odd. On one boot the audio worked. The only difference I noticed was that when I mounted the D1S1 EFI it wasn't the one that I normally use to edit the config.plist. This time the D1S1 EFI had the following folders: EFI>APPLE>EXTENSIONS> and a single file: FIRMWARE.SCAP The D2S1 EFI had the the BOOT and CLOVER folders that I'm familiar with. Unfortunately on the next reboot the audio stopped working and the EFI folders went back to their usual place. Any Suggestions? Edited March 17, 2015 by abxnightpilot Link to comment https://www.insanelymac.com/forum/topic/305106-audio_realtekalc-100v104dcommand/ Share on other sites More sharing options...
Recommended Posts