Jump to content

Looping at text(Cannot boot) Panic?


1 post in this topic

Recommended Posts

So I finally got the OsX 10.4.7 to install onto an IDE ATA drive. Once the DVD install completed, it rebooted, and then it goes into this black screen with text running down. After that, on the bottom of the screen, it will show some hex codes real quick, and then go back to a string, and then repeat several times be fore rebooting the PC. Any ideas? I installed the DVD with only the Intel patches. Running an intel P4 2.66 on a MSI PT880Neo board.



I believe it has something to do with Panic, but not sure what that means exactly. It showed that on the screen.


Figured it out, was SSE issue.

Link to comment
Share on other sites


  • Create New...