Jump to content

No Screen after Darwin Loader


Nolis
 Share

1 post in this topic

Recommended Posts

I use a prepaird 10.7 GM with Boodloader Camelion (did it like one of these tutorials of to create a hack OSX Lion from here).

 

This one works pretty good on an Fujitsu Siemens Notebook (Phoenix Bios): I booted with the -v string

 

darwing loading some files for a second, then it switch the resolution a bit and starts loading some files (black srceen with lines) for some seconds.. and the UI Install Screen appears (WOW)....

 

but on my MSI- G41M-P25 (Award Bios) and the Asus- P5KTL-VM is now screen coming up after darwin...

 

If the Boodloader is up, I start it with the -v string to see whats going on... it loads the darwin files till the point where the resolution changes.. (on the Siemens Notebook I can see that on this point it starts to load the osx installation files, I think thats why the resolutione change)... On the asus or msi board it is just turns to black, no screen, now white lines showen, just black.. but the monitor is receiving a signal because the led is not turning to red ... no UI also after 30 mins.

 

whats wrong ? (any ideas.. I thought maybe a graphic problem (I use the onboard cards only)...

Link to comment
Share on other sites

 Share

×
×
  • Create New...