ATI HD4850 Question

[bob78h]

Hey guys,

I'm about to follow this guide to install Snow Leopard

http://www.insanelymac.com/forum/index.php...amp;mode=linear

 

But before I begin I want to figure out how to get my HD 4850 to work. It has 2 DVI ports and I currently have 1 DVI-VGA adapter that I am using with my monitor (don't have any DVI cables). I'm a little confused as to what method I should use to get my card working. Is the netkas method most likely to work? What about Kabyl's chameleon or using Lizard?

 

If I use PC EFI from netkas, how does that work during the install? Blackosx's guide is using chameleon so how would I go about using PC EFI, a little confused about this? And also I'm unclear on the DVI-VGA dongle, I only have one and I need it to use my monitor with a VGA cable, will this work or will I have to buy another dongle to put in the other DVI port?

 

Thanks, looking forward to finally getting started on this install.