Jump to content

Hackintosh video and boot problem


2 posts in this topic

Recommended Posts

Hello. Has decided to install hackintosh on the PC.

Put through EasyEFI v2.2 plus the Retail 10.6.3. There are two problems:

1) the System for any reasons isn't started from a hard (usbmsc device non-unique) though from a disk all is normal

2) When it is cut natit.kext, system starts to brake rigidly, sharp jerks, jumps of mice (to operate very difficult), keyboard delays (0,5 seconds approximately), but are visible that acceleration has earned (the top panel), however system all the same works slowly.

Configuration:

Asus m2n32-sli deluxe

AMD x2 6000 +

4 gb ram

Gt 430

System - 10.6.7

Help, please. In advance thanks.

 

P.S. If this problem already was on your forum, please forgive me, because i am russian and i have difficulties with special words in english.

Link to comment
Share on other sites

Hello. Has decided to install hackintosh on the PC.

Put through EasyEFI v2.2 plus the Retail 10.6.3. There are two problems:

1) the System for any reasons isn't started from a hard (usbmsc device non-unique) though from a disk all is normal

2) When it is cut natit.kext, system starts to brake rigidly, sharp jerks, jumps of mice (to operate very difficult), keyboard delays (0,5 seconds approximately), but are visible that acceleration has earned (the top panel), however system all the same works slowly.

Configuration:

Asus m2n32-sli deluxe

AMD x2 6000 +

4 gb ram

Gt 430

System - 10.6.7

Help, please. In advance thanks.

 

P.S. If this problem already was on your forum, please forgive me, because i am russian and i have difficulties with special words in english.

 

Hey, guys! I found the solution. Half of it, look:

 

More shortly, while such, it is necessary to remove the decision AppleGraphicsPowerManagement.kext, and after system restart to make for 1 second the monitor in a dream mode (I have put transition in it with on one of active corners). After an exit from a dream isn't present the slightest hint on brakes.

Link to comment
Share on other sites

 Share

×
×
  • Create New...