Jump to content

MSI 865G Neo2 und Hackintosh?


1 post in this topic

Recommended Posts

Mein Mainboard: MSI 865G Neo2 allgemein:



· Supports Intel® P4 Northwood/Prescott (Socket 47cool.gif processors.

· FSB 400 (for Northwood only), 533, 800MHz.

· Supports up to 3.2GHz or higher speed.


· Intel® 865PE/G chipset

- Supports FSB 800/533/400MHz.

- Supports AGP 8X interface.

- Supports DDR 400/333/266 memory interface.

- Integrated graphics controller (for 865G only).

· Intel® ICH5/ICH5R chipset

- Hi-Speed USB (USB2.0) controller, 480Mb/sec, 8 ports.

- 2 Serial ATA/150 ports.

- 2 channel Ultra ATA 100 bus Master IDE controller.

- PCI Master v2.3, I/O APIC.

- Supports both ACPI and legacy APM power management.

- Serial ATA/150 RAID 0 and RAID 1 (Optional).

Main Memory

· Supports four unbuffered DIMM of 2.5 Volt DDR SDRAM.

· Supports up to 4GB memory size without ECC.

· Supports Dual channel DDR266/333/400/433/466/500/533 MHz and up.

(DDR433/466/500/533 are overclocking spec)


· One AGP slot supports 8x/4x at 0.8V (AGP 3.0) or 4x at 1.5V (3.3V is not


· Five 32-bit v2.3 Master PCI bus slots (support 3.3v/5v PCI bus interface).

On-Board IDE

· Dual Ultra DMA 66/100 IDE controllers integrated in ICH5/ICH5R.

- Supports PIO, Bus Master operation modes.

- Can connect up to four Ultra ATA drives.

· Serial ATA/150 controller integrated in ICH5/ICH5R.

- Up to 150MB/sec transfer speeds.

- Can connect up to two Serial ATA drives.

- Supports SATA RAID 0/RAID 1 (Optional).



P4 2,6 GHz

Grafic: GeForce FX5500

S-ATA 250 GB (first master, but there is my Win7)

IDE 20 GB (third master, for Hackintosh)



Nun ich hab diverse Distris durch:


iAtkos v.7:

installiert aber bootet dann nicht "waiting for bootdevice"

neheme ich S-ATA ganz raus (Hardware und Bios) dann habe ich einen KernelPanic wenn ich von DVD booten und installieren will

iAtkos S3 v.2

DVD startet, ich kann die Installation anpassen, aber dann fängt er nicht an zu schreiben

Hazard 10.6.6i

siehe iAtkos S3 v.2


Irgent was passt da nicht

Link to comment
Share on other sites


  • Create New...