Snow Lepoard and HD 5870

[deathsonic18]

Hey Guys, I was looking around and around the forum trying to see how I can fix this problem :S

 

Basicly I followed the amazing guide by digital_dreamer on : Guide

 

now I got a intel i7, DX58SO Motherboard, 6 GB RAM and Sapphire HD 5870.

 

So I installed iAtkos 5i on 1 HDD (lets give it a name: HDD1), and from there I setup the bootloader etc etc on the other HDD (lets give it a name: HDD2).

 

now, when I come to boot up the HDD2, it comes up and the bootloader loads(then it shows all the kext's loading up), then a blank screen appears saying: Check signal cable, now if I boot up iAtkos 5i from the BOOTLOADER of HDD2 the same thing happens.

 

If I boot up iAtkos 5i from the BOOTLOADER from HDD1. It work's fine.

(to install iAtkos 5i, I used this Guide : Guide 2.

 

Thanks in Advance for any help!, I really need it, i'm still really new to this >.<

 

Best Regards

deathsonic18

[Dellxpsowner]

Hello,

 

I thought 'check signal cable' means that you are trying to boot from network. So can you post the log from the previous screen, where all the kexts are written?

[deathsonic18]

The problem is that, when the kernels start's up, they go down to the bottom of the screen, then the screen refresh's

So in all there are about 8 different screens... are they saved in a log somewhere ?