kalmdave Posted December 26, 2010 Share Posted December 26, 2010 I had three Hard Drives: 1. 500GB Windows7 Enterprise 32bit. 2. 320GB Samples and Libraries with three partitions. 3. 250GB Snow Leopard 10.6.3 iAtkos S3 v2 Now I get Blue Screen Of Death (BSOD) whenever i access Win7 Hdd. My OSX drive works all fine. My MBR has been lost that's what the recovery disk diagnosis mentions. Am on P5B-Mx wifi/ap. Is there any chameleon bootloader command or OSX terminal command or OSX program like EasyBCD? Link to comment Share on other sites More sharing options...
kalmdave Posted December 28, 2010 Author Share Posted December 28, 2010 I had three Hard Drives: 1. 500GB Windows7 Enterprise 32bit. 2. 320GB Samples and Libraries with three partitions. 3. 250GB Snow Leopard 10.6.3 iAtkos S3 v2 Now I get Blue Screen Of Death (BSOD) whenever i access Win7 Hdd. My OSX drive works all fine. My MBR has been lost that's what the recovery disk diagnosis mentions. Am on P5B-Mx wifi/ap. Is there any chameleon bootloader command or OSX terminal command or OSX program like EasyBCD? I guess, it would not. And also that's too much too ask. But this is what I did and it worked. Set the Win7 HD first in Bios HD boot order and run startup repair from the Win7 dvd - it may take 3 runs.I that doesn't work, boot the Win7 dvd to command prompt, type ( press enter after command) :Diskpartlis vol ( find the letter for the volume you installed Win7 on - replace with ? below) sel vol ? [Mine was F: here] act exi Then run startup repair - up to 3 times. Regards Link to comment Share on other sites More sharing options...
Recommended Posts