ASUS A8N-VM CSM

[ssprod]

Please Note----> Internal 6150 Video disabled, as it is not supported//Using an Asus 8400GS pci-3 256meg card instead

Problem------>Greetings, and thanks in advance! Hazards' 10.6.2 install successfully installs with LEGACY kernel, ElliotForce reset, AMD, and NVEnabler, however as clear as the graphics are, and System Profiler recognizes 8400GS...mouse tearing, jerking and horrible delayed latency in commands makes it unusable. When I remove NVEnabler, all is good in terms mouse control and reaction to executable programs, but accelerated graphics and the card is not recognized. I've also tried (separately, of course) NVinject, Kush, etc with no positive results. Any thoughts would be greatly appreciated. 2 Other methods have resulted in exactly the same problem - Method 1-change Boot plist to include Graphic Enabler=yes AND PciRoot=1// Method 2 -edit NVResman, and Hal kexts to include proper video card device id

Any suggestions up and beyond what I've struggled with to date would be greatly invited and appreciated. Thanks. ssprod

(Asus A8N-VM CSM (2 PCI, 1 PCI-E x1, 1 PCI-E x16, 4 DDR DIMM, Audio,

Video, Gigabit LAN, IEEE-1394 ON BOARD GRAPHICS-NVIDIA GeForce

6150--DISABLEDNvidia GeForce 8400GS 256meg PCI-ECPU-DualCore AMD

Athlon 64 X2, 2400 MHz (12 x 200) 4800+ RAM- 2 GIG HARD

DRIVE-WD 140GIG SATADVD Burner-IDE)