Snow leopard and leopard 10.5.8 errors after installation

[tino112]

Hi everyone ! Please help me with this problems.

 

First of all my spec system is:

Default first OS: Windows 7 32bit on a HDD 40GB

CPU Q6600 2.4Ghz

Main board: P5K

Graphic: Nvidia 8600GT

Audio: ALC883 codec

Ethernet: Atansic L1.

 

I installed my Windows 7 on 40GB Samsung HDD.

 

Then I have another HDD which is from Seagate. So i intended to install Mac OS X on this HDD -> two OS on two different HDD.

 

I install both OS on primary partitions of the 2 HDDs.

 

I successfully installed iDeneb or iPC OSX 10.5.6 into my system with Easy BCD 2.0.2 Mode setting for Mac OSX is "MBR". If i choose the "EFI (Default)" mode, i will get an error: \NST\nst_mac.mbr not found when i boot into the OSX.

 

If i use the Easy BCD 1.7.2, i will never have the chance to boot into the Mac OSX because it will show the same error as above. But back to time when i used Vista as default and then install OS X 10.5.6, i could successfully booted in to it with Easy BCD 1.7.2 with the mode setting "Generic x86 PC"

 

My problem is that i can not boot into Mac OS X Snowleo Snow leopard 10.6.1 or iDeneb 10.5.8

The two version got the same problems when i boot after i successfully installed them.

 

Each time i tried to install one of them, i always erased the Partition and formatted it into Mac Extension (Journal)

 

The first problems for both of them is that if during the setup customization, i choose the bootloader as Chameleon V2 (whatever the RC version is), then i will get the problem that when i boot into Mac OS X. It shows an error for both version of OS X which is "Memory Allocation error", "System halted".

 

The second problems for both of them is that if during the setup customization, i choose the bootloader as Chameleon V1 or do not choose any Chameleon bootloader. Then the issue is different that, when i boot to the OS X, it will shows an error that "Chain booting error". Then i went to Easy BCD 2.0.2 in Windows 7 and change the mode setting for Mac OSX from "mbr" to "efi (default)". After that i reboot into OS X and receive another error "Try: (hd0,0) NTFS5: ANG0".

 

Please help me! I've tried all my day with different choices and ways but no luck.

 

Thank you and sorry for my bad English.