Successful Installation of iAtkos S3 on Toshiba Satellite with Some Problems

[905]

Greetings to everybody and thanks for all the hard work to make this happen.

I have successfuly installed iAtkos S3 however I can only boot with -f -v, and sometimes -x -v. I have to try several times before I can successfully boot into Mac OSX. The times I can't get in I get a white/grey screen.

 

Attached are my hardware spec.computer_specs.tiff

 

I have installed the following from the iAtkos cd.

Anval Loader

32 bit boot

pcil

Ethernet

USB BusFix

EHCIaquire

Extra Directory

fakesmc

disabler

RTC 32 bit

PJ Kernel

Intel Sata IDE

Voodo Ps/2

Battery

Card Reader

Tsc Sync

GMA 950 27AE

Marvell Yukon 88E8056

 

Attached is a screen shot while booting with -v -x.

http://www.insanelymac.com/forum/style_images/lucidity//gif.gif

 

I am looking forward to your advise.

[sunlyee]

Greetings to everybody and thanks for all the hard work to make this happen.

I have successfuly installed iAtkos S3 however I can only boot with -f -v, and sometimes -x -v. I have to try several times before I can successfully boot into Mac OSX. The times I can't get in I get a white/grey screen.

 

Attached are my hardware spec.computer_specs.tiff

 

I have installed the following from the iAtkos cd.

Anval Loader

32 bit boot

pcil

Ethernet

USB BusFix

EHCIaquire

Extra Directory

fakesmc

disabler

RTC 32 bit

PJ Kernel

Intel Sata IDE

Voodo Ps/2

Battery

Card Reader

Tsc Sync

GMA 950 27AE

Marvell Yukon 88E8056

 

Attached is a screen shot while booting with -v -x.

http://www.insanelymac.com/forum/style_images/lucidity//gif.gif

 

I am looking forward to your advise.

 

Exact same issue with dell inspiron e1405

i selected both drivers for intel gma950 on first boot i tried cpus=1, i have only blank screen after apple logo, i can hear startup sound but no thing to see. i booted with installation usb of iatkos s3 which i prepared with netbookbootmaker with some extra kexts for my laptop(droped in /extra on installation usb root i.e voodoops2 etc), then selected my hard drive where i installed iatkos SL.

now i can see installation screen. i completed setup and rebooted from HD. same issue again. i could only boot with usb. then i added all kexts from usb/Extra to /Extra on HD. rebooted with cpus=1 -f. now every thing is fine. but i always needed to boot with cpus=1 -f. so i added these to com.boot.plis in /extra. but still searching to get rid of " -f ".