thexperiment Posted July 3, 2010 Share Posted July 3, 2010 install distro: patched leohazard bootloader: chameleon rc3 with pc efi 10.5 version: 10.6.0 specs xfx 680i lt sli q6700 4gb ram IDE hdd and dvd 9800gt kexts bootx86 NvEnabler NforceLan VoodooHDA AppleRTC(get kernel panics with elliotforcelegacyrtc) IOATAFamilyFix SMBIOSResolver details Had the firewire guid ffff... is invalid during boot so i disabled firewire. Also during boot Nvenabler has quite a few lines of debug. Also during the boot AppleNforceATA found 0 units. After it boots into osx and i begin installing my software thats when i received this kp --sorry if im posting in the wrong section...first post. anyways, thanks for the help =) Link to comment Share on other sites More sharing options...
verdant Posted July 3, 2010 Share Posted July 3, 2010 installdistro: patched leohazard bootloader: chameleon rc3 with pc efi 10.5 version: 10.6.0 specs xfx 680i lt sli q6700 4gb ram IDE hdd and dvd 9800gt kexts bootx86 NvEnabler NforceLan VoodooHDA AppleRTC(get kernel panics with elliotforcelegacyrtc) IOATAFamilyFix SMBIOSResolver details Had the firewire guid ffff... is invalid during boot so i disabled firewire. Also during boot Nvenabler has quite a few lines of debug. Also during the boot AppleNforceATA found 0 units. After it boots into osx and i begin installing my software thats when i received this kp --sorry if im posting in the wrong section...first post. anyways, thanks for the help =) See my nForce chipset MOBO Snow Leopard Install Guide here......and my blog for Snow Leopard install guides....... Link to comment Share on other sites More sharing options...
thexperiment Posted July 4, 2010 Author Share Posted July 4, 2010 See my nForce chipset MOBO Snow Leopard Install Guide here......and my blog for Snow Leopard install guides....... Hi thanks for the reply Im following your guide using the nForceSLBoot 132 CD method however when i boot off the disk i get an EBIOS read error: "error 0x32 Block 0xb0 Sectors 0". any suggestions? Link to comment Share on other sites More sharing options...
verdant Posted July 4, 2010 Share Posted July 4, 2010 Hi thanks for the replyIm following your guide using the nForceSLBoot 132 CD method however when i boot off the disk i get an EBIOS read error: "error 0x32 Block 0xb0 Sectors 0". any suggestions? It may still boot if you wait a while ........but better to follow the instructions in post #1: "N.B. Burn the DVD at the slowest possible speed ≤ x4"..........i.e. burn to a DVD-R or DVD+RW NOT to a CD-R or CD-RW........hence the name nForceSLBoot132DVD....... Link to comment Share on other sites More sharing options...
Recommended Posts