Eric-PTEK Posted June 22, 2010 Share Posted June 22, 2010 I'm trying to setup 2 machines. The first one with the EP45 board went super smooth. I put in a 9800GT to get it up and running. I used the Lifehacker article and it worked fine. I then swapped in a GTX275 and it boots but I cannot get the drivers to load. I followed a few sets of directions but it still doesn't show up properly, video performance even in OSX is poor. The other machine is a bigger problem. A Core i3 H55M-UD2H with 4 gigs of ram and a 150 gig Velociraptor. I used [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] generic(the non-ATI/NVIDIA) and it installs fine including the network working. I try to do the 10.6.4 package update and the first time it worked but I screwed something else up so I reloaded the machine. Now it tells me I have to reboot the system, then the installer crashed. I figured no big deal it was done. I ran [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] and tried the custom DSDT but it never asked me for the file so I popped in the DSDT.aml file for the board that I found into the Extra's folder. Now it starts to boot and sits at the spinning wheel and grey screen. I've heard that the Intel graphics are supported and I've heard they were not, which is it? Otherwise I can put in the 9800GT in that box but I don't think its the issue. Should I put the aml file in Extra's? Not sure what should go where. I'm pretty close so any help would be greatly appreciated. Link to comment Share on other sites More sharing options...
Recommended Posts