mishak Posted June 18, 2010 Share Posted June 18, 2010 I installed Snow Leopard on Apple SW RAID 0 with two Solid State Drives: Vertex Limited Edition 100 GB. Everything installs fine but when I try to boot, Chameleon goes through 'boot0 done' and then hangs!? OS boots fine if Chameleon starts from another HD or memory stick and then gets redirected to RAID0 drive! Everything also works great if I use only one SSD. MB is DX58SO with i7 920 CPU with 6GB DD3 Corsair 1600 memory. No over-clocking. Thanks for any idea how to solve the issue. Link to comment Share on other sites More sharing options...
mishak Posted July 18, 2010 Author Share Posted July 18, 2010 I installed Snow Leopard on Apple SW RAID 0 with two Solid State Drives: Vertex Limited Edition 100 GB. Everything installs fine but when I try to boot, Chameleon goes through 'boot0 done' and then hangs!? To answer my own question, in case somebody else bumps into a similar problem: There are no problems with Vertex LE in RAID0 configuration!! OSx86 boots without a problem as long as you copy entire "Extra" folder and "mach kernel" to "Boot OSX" partition. (Not mentioned in Chameleon README file!). Link to comment Share on other sites More sharing options...
cairo_sc Posted September 12, 2010 Share Posted September 12, 2010 Nice tip bro, i got to reinstall my whole system 'cause i had no idea how to make it boot from my raid0. thx a lot! Link to comment Share on other sites More sharing options...
Recommended Posts