estofan Posted January 15, 2010 Share Posted January 15, 2010 after a lot of tries i give it up to start my osx 10.6.2 from the onboard raid controller...... i installed a highpoint rocket raid 2300 pcie controller, configured the raid to level one and the disk appeared on my desktop. i installed osx with the gygabyte usb stick. if i start using the usb bootloader the new raid hd and system works well. but when i trie to start from the disk directly the bottloader says : " boot0 error " what can i do ???? has anybody some expiriences ???? would be very nice to get any help ! thx a lot Link to comment https://www.insanelymac.com/forum/topic/207450-raid-configuration/ Share on other sites More sharing options...
happyguru Posted January 16, 2010 Share Posted January 16, 2010 ok i had the smae problem too. and i had no idea what i was missing. what i was doing wrong was my mac drive was not on primary partition. so i had to go around my win 7 4 primary partition limit and made my mac os primary partition and then made it active. if u google it you can find how to active a partition drive using command prompt in windows. hope this helps good luck. P.S I couldnt install the mac os 10.6 but i have sudessfully installed. iaktos v.7. if that helps too after a lot of tries i give it up to start my osx 10.6.2 from the onboard raid controller...... i installed a highpoint rocket raid 2300 pcie controller, configured the raid to level one and the disk appeared on my desktop. i installed osx with the gygabyte usb stick. if i start using the usb bootloader the new raid hd and system works well. but when i trie to start from the disk directly the bottloader says : " boot0 error " what can i do ???? has anybody some expiriences ???? would be very nice to get any help ! thx a lot Link to comment https://www.insanelymac.com/forum/topic/207450-raid-configuration/#findComment-1386904 Share on other sites More sharing options...
Recommended Posts