Jump to content

Use BCM5787 ethernet card driver, lose restart and shutdown


leech008
 Share

2 posts in this topic

Recommended Posts

I have installed the hazard ver. 10.6.2 MAC OS X on my acer 4710 laptop. Everything goes well except my pci ethernet card BCM5787m. So I get its driver from kexts.com and finally make it working for me. But at the same time, my laptop can not restart or shutdown normally(each was halted in "mach reboot" or "cpu halted"). All I can do is to press the power button. I can get my normal restart and shutdown back only if I remove the driver. Anyone who have the same problem, pls help~

Link to comment
Share on other sites

  • 3 months later...
I have installed the hazard ver. 10.6.2 MAC OS X on my acer 4710 laptop. Everything goes well except my pci ethernet card BCM5787m. So I get its driver from kexts.com and finally make it working for me. But at the same time, my laptop can not restart or shutdown normally(each was halted in "mach reboot" or "cpu halted"). All I can do is to press the power button. I can get my normal restart and shutdown back only if I remove the driver. Anyone who have the same problem, pls help~

 

same problem in my lenovo r500 with the bcm5787.

Did you find any solution?

 

Thanks

Link to comment
Share on other sites

 Share

×
×
  • Create New...