shntat Posted December 26, 2009 Share Posted December 26, 2009 <P>snow leopard from hazard installs and boots </P> <P>dvd drive works on red esata connector near processor </P> <P>and everything else works aswell </P> <P>thanks hazard </P> i found out that you have to install from regular sata then switch it over to the red sata connector you cannot boot from red sata comming soon the options i used to install Link to comment https://www.insanelymac.com/forum/topic/203974-snow-leopard-1062-from-hazard-works-on-xfx-790i/ Share on other sites More sharing options...
shntat Posted December 27, 2009 Author Share Posted December 27, 2009 updated above Link to comment https://www.insanelymac.com/forum/topic/203974-snow-leopard-1062-from-hazard-works-on-xfx-790i/#findComment-1369772 Share on other sites More sharing options...
nightrider Posted December 30, 2009 Share Posted December 30, 2009 Hey could you please post the options you used to install?? Link to comment https://www.insanelymac.com/forum/topic/203974-snow-leopard-1062-from-hazard-works-on-xfx-790i/#findComment-1372259 Share on other sites More sharing options...
shntat Posted December 30, 2009 Author Share Posted December 30, 2009 the options i used to install on my xfx 790i were osx 10.6.2 camleon rc3 pcefi 10.5 graphics enabler nvenabler hda enabler "legacy ac888 4out2inregular headphones" applertc ioatafamilysatafix smbios resolver uuid x11 rosetta dont forget to transfer atapi disc drive to jmicron esata connector after install because the drive wont work otherwise Link to comment https://www.insanelymac.com/forum/topic/203974-snow-leopard-1062-from-hazard-works-on-xfx-790i/#findComment-1372596 Share on other sites More sharing options...
shntat Posted December 31, 2009 Author Share Posted December 31, 2009 after a few days i tried to run itunes and i get a kernal panic after a few minutes something with the block storage kext Link to comment https://www.insanelymac.com/forum/topic/203974-snow-leopard-1062-from-hazard-works-on-xfx-790i/#findComment-1373212 Share on other sites More sharing options...
xelarochi Posted May 15, 2010 Share Posted May 15, 2010 did you get your nforce sata working? i have nearly the same harware as you and I've just only been able to make them run booting in 32bit (arch=i386) With 32 bits it takes a lot to boot up and sometimes it doesn't finishes so that I came back to 64bit. Do you know if a applenforceata has been compiled in 64bit? Or have you had success with supernforceata? Does sleep function work to you? i cannot get it work but doesn't matter at all. I've been using it for a week more or less in 64bit using all kind of programs and no Kernel Panic Thanks Link to comment https://www.insanelymac.com/forum/topic/203974-snow-leopard-1062-from-hazard-works-on-xfx-790i/#findComment-1468951 Share on other sites More sharing options...
Recommended Posts