iDeneb 1.6 - P5QC - Black Screen Reboot -- Have Already Read! Please Help

[TrevTastic]

My Config:

 

Asus P5QC

Q9400 2.66ghz

8GB DDR2 Corsair 1066mhz

640GB WD SATAII <-- OSX Drive Only

XFX HD4850

 

Already patched bios with 1406 by Juzzi.

 

My Problems:

 

I have tried iAtkos, iDeneb, iPC, and I tried my hand at a retail snow leopard install (which i'm sure my dvd is bad... so nvm that one).

 

I recently got the iDeneb 10.5.8 to install (for the 4th time), but whenever I boot from the harddrive, it goes to the gray apple screen for 2-3 minutes, then my screen goes black, I get "no input" and nothing happens from then on.

 

Has done this every time.

 

I have installed every Kernel there is, to see if that is the problem. Everything else is installed per multiple P5Q guides...

 

Any ideas?! I'm at a loss.

[Nenad]

My Config:

 

Asus P5QC

Q9400 2.66ghz

8GB DDR2 Corsair 1066mhz

640GB WD SATAII <-- OSX Drive Only

XFX HD4850

 

Already patched bios with 1406 by Juzzi.

 

My Problems:

 

I have tried iAtkos, iDeneb, iPC, and I tried my hand at a retail snow leopard install (which i'm sure my dvd is bad... so nvm that one).

 

I recently got the iDeneb 10.5.8 to install (for the 4th time), but whenever I boot from the harddrive, it goes to the gray apple screen for 2-3 minutes, then my screen goes black, I get "no input" and nothing happens from then on.

 

Has done this every time.

 

I have installed every Kernel there is, to see if that is the problem. Everything else is installed per multiple P5Q guides...

 

Any ideas?! I'm at a loss.

 

 

 

Try with Snow_Leopard_10.6.1-10.6.2_SSE2_SSE3_Intel_AMD_by_Hazard. I succed with the same model of mobo.