Jump to content
3 posts in this topic

Recommended Posts

I have a problem that I hope that some of the great minds on this site can help me with. I have successfully install osx 10.5.7 with ideneb, after many tries i might add, and I can get it to boot. However every other time I have to boot in to safe mode with -x. After I boot into safe mode and restart I can boot up normally. Than the next time I have to go back to safe mode or else it wont boot. I have no idea what is causing this hopefully someone here can help me. Also as a side note I have a via vt1708s sound card built into my motherboard and I dont know what to do get the sound working (what kext to use).

 

AMD Phenom II x4 965 BE

ASUS M4A78T-E AM3 AMD 790GX/SB750 HDMI ATX AMD Motherboard (built in via vt1708s)

Radeon HD 4870 2GB 256-bit GDDR5 PCI Express 2.0 x16

G.SKILL 6GB (3 x 2GB) 240-Pin DDR3 SDRAM DDR3 1600

Western Digital Caviar Black WD7501AALS 750GB 7200 RPM SATA 3.0Gb/s 3.5" Hard Drive

 

P.s. this was posted from osx :lol: (got ethernet working finally)

For that you can use Azalia kext, you'll get 2 channels output.

 

another thing that just started happening is that now the kext helper says that it cannot login as root check password... i know that the password is correct because when I try to login with root at the login screen i put in the right password and the screen shakes for a second goes black and then back to login screen. Kext helper was working a couple days ago and Im not sure why it wouldnt be now. Any suggestions anyone?

×
×
  • Create New...