dandeloy Posted September 6, 2009 Share Posted September 6, 2009 hey so i installed osx86 on my optiplex gx280. It installed fine. BUt when i go to restart it staarts booting the kernal then screen goes black and restarts the computer and it does this over and over. My dad told me it was probably because of the video card which is a Intel 915GM(it says 915/910). Could someone tell me what to do next? Link to comment https://www.insanelymac.com/forum/topic/184531-help-after-install/ Share on other sites More sharing options...
punk_zappa Posted September 6, 2009 Share Posted September 6, 2009 Try to boot with the disc in the tray but don't boot off it and just wait to see if it will go through. I had mine like that and it will only boot with the disc in the tray. Link to comment https://www.insanelymac.com/forum/topic/184531-help-after-install/#findComment-1254608 Share on other sites More sharing options...
vilpostus Posted September 6, 2009 Share Posted September 6, 2009 I suspect a kernel problem there. Do you have any other kernels installed? If yes, try them. Link to comment https://www.insanelymac.com/forum/topic/184531-help-after-install/#findComment-1254682 Share on other sites More sharing options...
dandeloy Posted September 10, 2009 Author Share Posted September 10, 2009 dont know about other kernals? I used Ideneb 1.3/10.5.5 ad i tried with disk and tray and it would just start installation again Link to comment https://www.insanelymac.com/forum/topic/184531-help-after-install/#findComment-1260810 Share on other sites More sharing options...
Recommended Posts