wPrime Posted July 21, 2009 Share Posted July 21, 2009 Hi guys, I have an old Compaq Evo n620c laptop, which I don't really use anymore. I decided I'd DL the iDeneb 10.5.5 hack for mac on the PC. I burned it to a disk, and installed it. I partitioned my only drive in two: 10GB Mac Extended partition named 'Mac'. and the rest I left as Free Space in case I needed to put Windows back on later. I customized the install, and since I wasn't sure what drivers to install for my computer, I just selected to install everything. The installation went fine, and the computer rebooted. When it booted back up, I selected to boot from Darwin, and the Apple boot screen flashed up. The computer then just shuts off and turns back on. If I leave it, it will keep doing this untill I turn the computer off. Is there any reason it would be doing this? Is it that my computer can't support SSE2, or is it something I did wrong in the installation? Link to comment https://www.insanelymac.com/forum/topic/175910-running-ideneb-1055-on-compaq/ Share on other sites More sharing options...
wPrime Posted July 22, 2009 Author Share Posted July 22, 2009 bump Link to comment https://www.insanelymac.com/forum/topic/175910-running-ideneb-1055-on-compaq/#findComment-1206293 Share on other sites More sharing options...
ConfederateTyrant Posted July 22, 2009 Share Posted July 22, 2009 Check my thread, I had the same problem, and had to go to another OSx86 version. Link to comment https://www.insanelymac.com/forum/topic/175910-running-ideneb-1055-on-compaq/#findComment-1206298 Share on other sites More sharing options...
Recommended Posts