Jump to content
3 posts in this topic

Recommended Posts

Hi. After some fiddling, I finally got iATKOS v4i to install on my computer. In order to boot into it, i have to use the boot parameter "cpus=1." However, I do not have a dual core processor. Why is this? Second, Sleep does not work and neither does my wireless card. The monitor display rate is stuck at 1024x768 and 60 Hz. My specs are below:

 

Intel Pentium 4 CPU 3.06GHz, 3059 Mhz, 1 Core(s), 2 Logical Processor(s); 512 MB DDR2 RAM PC333; Intel 865G Graphics Chipset; Linksys WMP54G v4.1 Wireless-G PCI Card; iATKOS v4i ToH kernel 9.2.0, Darwin x86 Bootloader for MBR (Non EFI); AppleSMBIOS netkas

Link to comment
https://www.insanelymac.com/forum/topic/174333-iatkos-issues/
Share on other sites

I would give it another go at installing... I had the same problem all i did was re-installed... Nowits perfect. BTW make sure that the S.M.A.R.T option is turned of in the bios under the drive management. As this is wat i did before reinstalling.

 

 

I did get it working. Turns out that the partition was not active. After erasing the drive and repartitioning with one partition, I was able to get it working. However, I still have to use the boot param "cpus=1" in order to boot. Installed ToH Kernel 9.2.0 with iATKOS 4i and Darwin X86 for MBR (Non EFI). None of the other boot params (-v; -x, -s, -f) will work, I alwys get a message about kernel panic or the you must restart your computer in 4 different languages.

×
×
  • Create New...