Jump to content

iDeneb v1.4: problem when loading installation


scleone1987
 Share

1 post in this topic

Recommended Posts

Hi. I boot the system from the DVD with iDeneb v1.4, it loads the Darwin Loader (without any flags like -v -x) and the classic gray loading screen appears, with the little circle on the bottom which stops rotating after few minutes, exacly when my DVD player stops reading the DVD. How can I get the installation work fine?

P.S. with iAtkos v5i I had no problems installing 10.5.5

P.S.2 when I try to boot with the -v -x flags, this is the error shown on the screen:

 

11032009010.th.jpg

 

my PC config:

 

Mobo: AsRock 775i65g fsb 1066 MHz (North Bridge Intel Springdale-G i865G)

Processor DualCore Intel Core 2 Duo E6420, 2133 MHz (8 x 267), supported instructions x86, x86-64, MMX, SSE, SSE2, SSE3, SSSE3

RAM 2x1 GB A-DATA PC3200 (3.0-4-4-8 @ 200 MHz) (2.5-4-4-7 @ 166 MHz)

Video card Sapphire Radeon HD3850 AGP 8x 512 MB GDDR3

Audio card C-Media CMI9739A/9761 @ Intel 82801EB ICH5 - AC'97 Audio Controller

Realtek RTL8139 PCI Fast Ethernet Adapter

Maxtor 6V250F0 ATA Device (250 GB, 7200 RPM, SATA-II)

 

Thanks in advance

Link to comment
Share on other sites

 Share

×
×
  • Create New...