Jump to content
4 posts in this topic

Recommended Posts

:D Hi all,

 

I've been reading this forum for a bit now and finally decided to give OSX86 a try. I think I may have made some mistakes when I tried to install it however. I was under the impression that I needed an HFS partition so what I did was create a Partition on my only available HDD (this is a laptop). I completed the install (everything appeared to go well) and then proceeded to reboot the laptop. After the reboot I got an error stating that no operating system was found. I rebooted the computer a second time and let the Myzar DVD boot the system again and then went to the disk utilities. When I looked there It was showing the extended partition where the MAC software was installed but said it wasn't bootable, I tried the startup utility but the only drive listed was the optical. What am I doing wrong?

Link to comment
https://www.insanelymac.com/forum/topic/14732-myzar-1044-on-sony-sz160/
Share on other sites

×
×
  • Create New...