Jump to content

Bcm440 Not Working After Starting Windows

1 post in this topic

Recommended Posts

I've been messing with this for a few days. Every now and then my BCM440 worked and then it didn't. I've googled around for a bit and found out that this is not a unknown problem for 'older' drivers, the older drivers for linux and *bsd suffered the same problem. I found out that after booting windows i don't have network anymore! The solution to this is take of the power, remove the battery for a little while, put it back, start your computer and it will work again! Seems windows does some rough initializing of the network adaptor.

Hope this helps some people :angry:

Link to comment
Share on other sites


  • Create New...