no booting after installing OS X86 on PC

[prko]

Hello,

 

I've just installed the Myzar DVD: OS X 10.4.5.

The installation was succesful.

But OS X doesn't start.

 

My Computer System:

Primarily Master: 80GB Seagate

Primarily Slave: 80GB Seagate

Secondary Master: DVD rewriter

Secondary Slave: CD rewriter

on PCI slot: Promise TX2000: Raid controller (The Harddisks on thi controller are not accesible during the installing.)

 

I have installed OS X on the Primarily Slave.

There were unallocated free space and NTFS partition.

I have allocated new partition on free space.

There was error.

The NTFS partition was also erased.

Then I have allocated two partitions.

All, what I have installed after that, was succesful.

But I select the Secondary slave for booting, there is no response.

After the booting with installation DVD, I can see the installed OS X 10.4.5.

After the booting with windows XP, I can't see no partition information on primarlily slave drive.

 

How can I solve this problem?

[powrslave]

boot from dvd

at the first screen go to the top

select disk utility

select your slave drive (the one you want to install osx on)

format as mac osx journaled is fine)

install

when you reboot boot off the partition either by hitting a key which gives you drive selection or modifying your first drive you want to boot

 

Under xp the filesystem will just be blank for that drive but it will see it..don't even look at it under xp

[prko]

I installed again with new partitions.

There is no problem.

[powrslave]

you are welcome?