Soprano Posted November 21, 2008 Share Posted November 21, 2008 I've had nothing but issues with this since upgrading to 10.5.3. When transferring large amounts of data through the network, it dies with several of these messages in Console: Nov 9 09:38:11 Hackintosh kernel[0]: AppleYukon: 00000010,00000272 skgesirq - AppleYukon: error - PCI express protocol violation error Nov 9 09:38:11 Hackintosh kernel[0]: AppleYukon: 00000010,00000264 skgesirq - AppleYukon: error - unexpected IRQ Status error Nov 9 09:38:11 Hackintosh kernel[0]: AppleYukon: 00000000,00000000 skgehw - cppSkDrvEvent - SK_DRV_ADAP_FAIL Nov 9 10:03:40 Hackintosh kernel[0]: AppleYukon: 00000000,00000000 PwrSavingsEED - Failed to get ACPI device Nov 9 10:03:40 Hackintosh kernel[0]: AppleYukon: 00000008,000002bd sktwsi - AppleYukon: error - TWSI: transfer does not complete The only fix is to reboot. I've tried serveral different AppleYukon2 kext's, but the result is still the same. Does anyone know how to fix this problem? I am running this Kernel: Version 9.4.0: Fri Aug 1 21:34:49 EST 2008; ToH & StageXNU:xnu-1228.5.20/BUILD/obj/RELEASE_I386 i386 My board is a Gigabyte GA-965p-DS3 vers. 3 Link to comment https://www.insanelymac.com/forum/topic/137548-1055-and-marvell-yukon-88e8056-drops-under-load/ Share on other sites More sharing options...
Soprano Posted November 24, 2008 Author Share Posted November 24, 2008 Nobody has any clue how to fix this? Link to comment https://www.insanelymac.com/forum/topic/137548-1055-and-marvell-yukon-88e8056-drops-under-load/#findComment-976298 Share on other sites More sharing options...
komeet Posted January 5, 2009 Share Posted January 5, 2009 I had the same problem and I found out it was due to the old AppleYukon.kext. This kext solve my problem and my internet connection is stable now. Maybe you have to modify the AppleYukon2.kext because it's for 88E8055. Good Luck. Link to comment https://www.insanelymac.com/forum/topic/137548-1055-and-marvell-yukon-88e8056-drops-under-load/#findComment-1027402 Share on other sites More sharing options...
Beerkex'd Posted January 8, 2009 Share Posted January 8, 2009 Oh wow. This is so much better than the archaic AppleYukon.kext from 2006 that I've been using up until now, because I couldn't figure out how to modify AppleYukon2.kext correctly. I was getting some of the same errors at boot as Soprano with the old AppleYukon. Your kext works perfectly fine with 88E8056, no modifications needed, it's already in the plist. Booting with -v there's just a short 'It lives!' message at the very end. Perfect! Link to comment https://www.insanelymac.com/forum/topic/137548-1055-and-marvell-yukon-88e8056-drops-under-load/#findComment-1031481 Share on other sites More sharing options...
Recommended Posts