Jump to content

Help me to apply the iDeneb v1.3 10.5.5 nForce patch


2 posts in this topic

Recommended Posts

Hey guys, i can't apply the patch for iDeneb 10.5.5, is little bit complicate to understand how to do that.


There is a read me file that explain how to do that on windows but for me is not clear. Below you have their recommendations to apply to patch.




Enter the following command in the terminal to run the patch (read carefully the legend before run the command)





ApplyPPF3 a original_iso ppf







ApplyPPF3 = path of file ApplyPPF3


a = command for apply the patch


original_iso = path of the iso iDeneb v1.3 10.5.5 not patched


ppf = path of the ppf patch





Applied the patch, you should check if the patch has been applied right with the following md5 checksum.



So help me please, if you can make a screen shot of all the ways to do that...



Link to comment
Share on other sites

  • 3 months later...

u can try this link....

Link to comment
Share on other sites


  • Create New...