Don't complete DVD boot before instalation

[FelipevanSchaik]

Hi!

 

I'm new in MAC OS X86... I want to try it, because I'm sick of windows. And Linux didn't do the job for me.

I'm very experient user of windows and far to be a dumb on linux. I've done too many (I can't remember the exactly number, over 400 times) windows and linux instalation, all without problems.

 

The configuration of my PC is:

 

Intel Pentuim 4 HT 3.2ghz (478)(Prescott) 1mb L2, sse3...

MB Intel D865PERL (sound on only)

4x 512mb DDR 400mhz Kingston KVR

VGA Nvidia GeForce FX 5200 128mb AGP

LAN Realtek 8139 PCI

DVD-RAM HL-DT-ST GSA-H44N ATA Device

Trying to install on a HD Maxtor 80gb IDE

Also have (unplugged) HD Seagate 250gb SATA

 

I've downloaded the Kalyway 10.5.2 version...

 

Boot from DVD. Don't type any options in the prompt.

After a while it don't complete the boot precess. Until now, there were 2 errors (apparently).

 

My first error was:

 

IOATAController device blocking bus.

 

As say in the forum, I put the DVD-RAM as Master and the HD as SLAVE. Didn't occured the IOATA error.

 

After this, came the following error (I supposed)(the last three lines):

 

CODE SIGNING: cs_invalid_page: p = 41[config] clearing CS_VALID

SAM Multimedia: READ ou WRITE failed, SENSE_KEY = 0x06, ASC = 0x29, ASCQ = 0x00

Aug 18 localhost diskarbitrationd[44]: coreRAIDserver [43]:16387 not responding

 

I'm really interested in complete the MAC OS instalation. So please help me!

 

Best regards for all!

 

Thank's

[MrAnnet]

Same problem (=message) with my attempt of installation.

 

Anyone??

 

("...localhost diskarbitrationd[44]:CoreRAIDServer [43]: 16387 not responding.")

 

I also have HDD and DVD-RW as master on different IDE channels.