bcohen4 Posted July 30, 2008 Share Posted July 30, 2008 I have tried just about everything, I posted this in installation section but I think that was the wrong place. Ok, no matter what settings I use to install I get a "Successful Installation". I select things that match my hardware, I don't just check anything that looks good. Then I go to reboot from the Hard Drive that I installed to and the message "You need to restart your computer" in four languages comes up everytime, even if I reboot 100 times (I think this is due to a kernel panic?). In Verbose mode this is where it stops: I tried the -s and making a new password but it still freezes! This is so frustrating and I simply do not have time to continue aimlessly re-installing. -Seagate Barracuda 7200.10 250GB 7200 RPM SATA 3.0Gb/s Hard Drive -GIGABYTE GA-EP35-DS3L LGA 775 Intel P35 ATX Intel Motherboard -GIGABYTE GV-RX387512H Radeon HD 3870 512MB 256-bit GDDR3 PCI Express 2.0 x16 HDCP -CORSAIR 4GB (2 x 2GB) 240-Pin DDR2 SDRAM DDR2 800 (PC2 6400) -Sony DVD+/-R DVD Burner SATA I had heard good things about the compatibility of this motherboard and a H4cklnt0sh but so far it's a no-go. Any help and/or suggestions for different custom installs are much much much appreciated. Thanks everyone in advance! Link to comment https://www.insanelymac.com/forum/topic/118368-kalyway-1052-will-not-boot-after-install/ Share on other sites More sharing options...
pahncrd Posted July 30, 2008 Share Posted July 30, 2008 Try not changing anything in the customization options except for ticking your video driver. Also, be sure you don't install the "64-bit" kernel as all the kernals are 64-bit and that one is specifically for AMD compatability. Try sleep kernel or vanilla. Link to comment https://www.insanelymac.com/forum/topic/118368-kalyway-1052-will-not-boot-after-install/#findComment-838970 Share on other sites More sharing options...
bcohen4 Posted July 30, 2008 Author Share Posted July 30, 2008 thanks I will try only ticking my video driver and see if that helps now. Link to comment https://www.insanelymac.com/forum/topic/118368-kalyway-1052-will-not-boot-after-install/#findComment-838996 Share on other sites More sharing options...
bcohen4 Posted July 30, 2008 Author Share Posted July 30, 2008 I am now getting stuck at: localhost /usr/sbin/ocspd[83]: starting any solutions for this? Link to comment https://www.insanelymac.com/forum/topic/118368-kalyway-1052-will-not-boot-after-install/#findComment-839055 Share on other sites More sharing options...
Recommended Posts