Jump to content
1 post in this topic

Recommended Posts

so after getting my new quicksilver and using osx on it, i decided i would upgrade the dvd drive to a burner and replace the 20gb hard drive with the 160gb in my windows Box. I then decided I would try osx86 again, the last time was like 2 motherboards ago with 10.4.8. I bought a new 320 gb sata Hatachi deskstar and installed it along with my new sata dvd burner in the windows box.

 

I heard that leo4all was the best so I used that. I also applied the "Leo4all V3 10.5.3 ppf by JaS" patch and burned the dvd from my laptop at 2x. the dvd booted up fine and went through the install fine. I dont remember the name of the filesystem it installed to, but it ended with journaling or something like that. on the first boot it wouldn't boot, so i went back and reinstalled using the older nforce chipset drivers think maybe it was the nforce4 causing the problem. on first boot, it did the same thing. Here's what it gave me in the picture.

 

and heres the page for my motherboard

Biostar NF4U AM2G

post-57252-1216494123_thumb.jpg

Link to comment
https://www.insanelymac.com/forum/topic/116616-leo4all-v3-problem/
Share on other sites

×
×
  • Create New...