Jump to content

GA-P35-DS3P Tiger -> Leopard


2 posts in this topic

Recommended Posts

Hi all. I'm currently dual booting OSX Tiger with Vista Business on a single hard drive (500GB)..


When i boot im taken to windows boot loader, if i choose osx from there it takes me to the darwin bootloader. And then i select osx and it boots into tiger


Now i want to start fresh using the kalyway 10.5.2 disk but im confused as to how to set up my bootloader/s


Ideally i'd like to dual boot again with vista ultimate



Edit: Also is it possible to run 10.5.2 with the hard drive on IDE mode using this motherboard? Cause running in AHCI, the hard drive is the component that is holding the system back from its full potential.

Link to comment
Share on other sites


  • Create New...