Leo4all v3 without video signal after installing

[Pipe1984]

Good, because then I can not install Leopard in the HP Compaq dc5700 because according to tell me the motherboard or chipset (q963) is not compatible with the XNU kernel (I find it strange that not even enter the installation). So I re-emphasised to install other equipment on my AMD. With this I was able to install iso (very fast throughout) with options for my hardware, after the installation restarts, booting the darwin smoothly, leaving muchisimas lines of code, they think it will come into the system for the first time , Ploffff appears on the monitor "so saving energy" and switched to stand by the monitor? led the hard disk flashes but nothing at all. My hardware is as follows:

 

AMD 3200+ 64 bits

Asus A8NE

2 GB de RAM

XFX Nforce 8500 GT

HD 160 GB SATA

 

He marked the Kernel 9.2.0 (the first of three that there is) the drivers for nForce chipset and drivers for Nvida graph. I find it strange that you install everything right and just when you start putting an Stand By mode on the monitor rather than video signal.

The case with 2 pcs individual can not install Leopard: (. Thanks in advance greetings